triangular plastic stock?

[hgraves]

I don't remember seeing it but is not this material avaliable?
the idea being to use as stringers on an smaller (1/300-1/400) model useing the method normaly applyed with balsa wood. (IE formers and stringers)
I find plastic to be much better behaved than any wood. expecially with small tight turns involved...
I am just thinking out-loud (out-typing?)
this model would then be coated with monokote.
the triangle cross section would give an small contact with the skin.

any thoughts ideas?...

[chilly]

I use plastruct all the time... I looked up their online catalog...and found this for you.

http://www.plastruct.com/Pages/OnlineCatalogDetail.lasso?GraphicKey=MRT-30

hope that helps.

chilly

[hgraves]

again i publicly prove my dorkness thou I knew plastruct existed i never imangined that it was so very Extensive

thanks for the link i do appreciate it...